Bresser TemeoTrend NBF Mode D'emploi page 41

NOTE!
To obtain a meaningful weather forecast you will need
to enter the correct height above sea level for your lo-
cation. When you have done this details of the relative
atmospheric pressure will also be displayed.
Registering a second or third external sensor:
The base station is able to display up to three external sensors. If
you want to register an additional sensor, select a free channel in the
battery compartment of the external sensor. Then select this channel
on the base station as well by using the CHANNEL button. Now insert
the batteries into the external sensor and then press and hold the
down arrow button (sensor call button) for approx. 3 seconds. The
black bars start to fl ash (indicating the sensor search function) and
the values of the new sensor will be displayed after approx. 2 minu-
tes. You can now alternate between the display for the two sensors by
pressing the CHANNEL button.
Random function:
The weather station is also equipped with a so-called RANDOM func-
tion. If this function is active the station automatically switches bet-
ween the registered sensors on a continuous basis. To activate or
deactivate this feature simply press and hold the CHANNEL button
for around 3 seconds. When the function is active a circular arrow is
visible underneath the channel display (CH) on your weather station.
If this arrow is not visible, the function is deactivated.
Sensor call button:
If ‚- -' appears in the display after this time instead of the external tem-
perature and humidity reading, then press and hold the down arrow
button on the front of your weather station for approx. 3 seconds.
The semi-circles above the CH symbol will then start to fl ash again
and another attempt is made to locate the signal from the external
41
GB/IE