Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
a)
b)
c)
3x
2.
a)
b)
c)
3.
a)
b)
c)
a)
b)
c)
5.
d)
e)
f)
d)
e)
f)
4.
a)
b)
c)
1x
b)
c)
6.
a)
3x
1. Installation and opening of the sunshade
a) Set the anchorage device in a suitable place. See to the correct di-
mensioning. Slide the pole over the support tube and turn it around
so that the pin can enter the notch.
b) Loosen the free-arm locking device.
c) Tilt and extend the free-arm.
2. Canopy rotation adjustment
a) Loosen the rotation locking device.
b) Adjust the rotation around the pole.
c) Fasten the rotation locking device.
d) The locking lever must be brought in its down position in order to
prevent possible injuries.
3. Canopy height adjustment
a) Loosen the height locking device. Adjust the height.
b) Fasten the height locking device.
c) The locking lever must be brought to its down position in order to
prevent possible injuries.
5. Closing of the sunshade
a) Disengage the ball-and-socket joint, bring the clamping lever into
an upright position.
b) Close the canopy by turning the crank.
c) Pull the covering fabric outwards disengaging it form the rods,
arrange it carefully and secure it with the binding belt.
d) Fasten the free-arm locking device.
e) Remove the binding belt. Open the sunshade canopy using the
crank. It turns in both directions.
f) Important: Open the sunshade always completely.
e) Tilt the clamping lever and disengage the ball-and-socket joint.
Bring the canopy in the requested position.
f) Re-engage the ball-and-socket joint by fastening the clamping
lever.
4. Free-arm adjustment
a) Loosen the free-arm locking device.
b) Bring the free-arm to the requested position.
c) Fasten the free-arm locking device.
6. Folding of the sunshade
a) Loosen the free-arm locking device.
b) Pull the free-arm back and bring it into an upright position.
c) Fasten the free-arm locking device. If necessary, pull the protective
cover over the sunshade.
GB
Publicité
Table des Matières
