Toto LLT152 Manuel D'installation page 5

1. Insert the LED strip
into the cover.
N OTE: See illustration
for the correct LED
orientation.
Up
Down
4. Plug the power adapter into a wall out-
let that is connected to a wall switch.
Power
Adapter
To replace the LED, follow this same procedure.
„ Run a continuous bead of caulk (not provided) around the sides of the lavatory.
„ Wipe away any excess sealant (caulk) and fill voids as necessary.
„ Allow the sealant to set for approximately 30 minutes.
1. Connect the water supply to the faucet according to faucet instructions.
2. Connect and tighten the trap to the drain.
3. Turn on the water supplies to the faucet.
4. Purge air from the hot and cold water by running the water for a few seconds.
5. Fill the lavatory with water.
6. Check for leaks at the water supply and drain connections.
Installation of Lighting
2. Place the LED cover
over the bottom of the
lavatory and secure it
with the screws.
LED
LED
Cover
Wall
Switch
Wall
Outlet
To Wall Outlet
120V AC 60 HZ
GFCI
To LED
Final Caulking
Faucet Connections (not supplied)
3. Connect the LED connector
to the power adapter.
LED
Cover
BEFORE CONNECTING
THE WIRING, TURN THE
POWER ADAPTER OFF
TO AVOID ELECTRIC SHOCK.
5. Turn the power adapter back on after
the wiring is complete, then test the
connection by activating the wall switch.
5
Power
Adapter
WARNING
Power
Adapter
Wall
Switch
CONFIRM