Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.1.7 PROGRAMMING/AUTOMATIC OPERATION WITH WEEKLY PROGRAMMING
Each day of the week can be programmed by setting the desired temperature in a specific time slot. A maximum of 7 time slots can be
defined for each day, and each time slot can be set to a different temperature value.
Example.
Set the day temperature values as follows:
Press
PROG
setting mode.
Keep
OK
Set the temperature of the first time slot of the first scheduling day (start time
at 12PM) by using "+" and "-" keys. Then press
Set the start time of the second time slot (corresponding to the end of the first
one) and press
to confirm and proceed to the third time slot and so on, until a maximum of 7
time slots.
Press
PROG
Keep
PROG
and use it for the following day.
To let the radiator work based on the set programming, select the "P1" mode using the "Mode" key.
4.1.8 DEROGATION IN LOCAL PROGRAMMING MODE
During operation in local programming mode, the set temperature can be edited compared to the one set in programming. The edited
temperature (derogation from the programmed temperature) is valid until the next programming change.
The displaying of a "Hand" shaped pictogram means that one derogation is in progress.
MODE
PROG
4.1.9 RE-READING OF THE STORED PROGRAMMES
The created programmes can be displayed.
1.
Starting from the standard operating mode, press the "PROG" key to display the created programmes (direct access if time has just
been set).
2.
Press "OK" to go through the different programme steps. Press key for more than 3 seconds to access again programme writing
mode.
EN-28
twice in the Normal Mode, or once if you are already in time
pressed for 3 seconds until the temperature starts flashing.
to confirm, then set the desired temperature and press
OK
to go at the following day and repeat the programming procedure.
pressed for 3 seconds if you want to copy the schedule just made
+
-
OK
to confirm
OK
MODE
PROG
OK
+
-
OK
Publicité
Chapitres
Table des Matières
