Keypad Lock; Window Status Acknowledgement; Open Window; Closed Window - Fondital MANIVA 3110 Manuel D'installation

4.2 Keypad lock

Starting from the standard operating mode, press "+" and "-" keys at the same time for at least 5 seconds until the "padlock" pictogram
appears on the display.
To unlock the keypad, press again for more than 5 seconds the
"+" and "-" keys at the same time, until the "padlock" pictogram turns off.
Note: When the product is in keypad locked mode, the ON/OFF key and thus the
switching off function are always active. The switching off does not cancel the keypad
lock in progress and, once product is switched on again, keys will be locked.

4.3 Window status acknowledgement

4.3.1 OPEN WINDOW

This function integrated inside the device is used to reduce the energy consumption resulting from the opening of a door or a window
overlooking a colder area when the device is in comfort, comfort (-1), comfort (-2) or eco status.
This function allows to automatically detect a sudden ambient temperature drop inside the room where the radiator is installed and to set
it to freeze protection mode.
Note:
If the opening of a window has been detected, press once the "OK/window" key to cancel this function and the product goes back to the
operating mode before detection.
The "WINDOW" pictogram shows that this condition has been detected and that the function has consequently been activated.
The "WINDOW" pictogram is steady on when the function is activated and it starts flashing every second when a temperature drop has been
detected.
Press the "OK/window" key to interrupt the window detection phase.

4.3.2 CLOSED WINDOW

This function allows quitting the freeze protection mode activated by a previous detection of the opening of a window on cold climate.
It allows to automatically detect an increase of the ambient temperature inside the room where the radiator is installed, subsequent to the
closing of the window, and to re-activate the operating mode active upon opening acknowledgement.
Once the previous operating mode is activated again (both after the detection of a temperature increase and when window key is pressed),
the "WINDOW" pictogram becomes steady again and the radiator starts operating again in the mode it was set to upon detection.

4.4 Accumulated consumption reading (kwh)

This function can be accessed by pressing "MODE" key for more than 5 seconds.
The displayed consumption is mathematically calculated based on the time for which the heating resistor is powered and is displayed in
KWh. It is calculated based on the radiator power defined in product configuration mode, hence it is not physically measured on the radiator.
To use this function, it is thus necessary to manually set radiator power as described in next paragraph 4.5.6.
Press key "-" for more than 5 seconds to reset consumption calculation.
This function will be automatically quitted after 5s.

4.5 Configuration mode

The configuration mode allows adapting the radiator to user's needs.
To access the configuration menu:
Press "Prog" key for more than 5 seconds.
Digit 1 will have the pointer next to it. By pressing the prog key again digit 2 will have the pointer next to it. Subsequently pressing the prog
key will move the pointer down to to the next digit number.
In case of inactivity for 120 seconds, the configuration mode will be automatically terminated
MODE
MODE
>5s
+
-
+
-
EN-29