Troubleshooting - Vornado ALCHEMY Guide D'utilisation

WARNING: To avoid risk of fire, electrical shock or injury to persons, power off
and unplug the Air Circulator before cleaning.
TIP: The motor is permanently lubricated and requires no oiling.
1
TO CLEAN MOTOR CAP AND INLET RIBS:
Use a common household vacuum. Do not use water to clean these
parts of the Air Circulator.
2
TO CLEAN GRILL:
Remove grill, (see grill removal instructions) and dust or wash with
a mild dishwashing soap. Do not place grill in the dishwasher. The
excessive heat can remove the plating.
3
TO CLEAN BLADE:
Wipe with a damp cloth. If your Air Circulator is used in a greasy
environment, such as a kitchen, mild soap or a common household
cleaner may be necessary. Do not use solvents.
12 English

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
UNIT FAILS TO Unit is not plugged in. Plug Power Cord into electrical outlet.
POWER ON
Ensure unit fan speed setting is selected.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
The outlet is worn or damaged. Try another outlet or contact a qualified electrician.
AIRFLOW IS Unit set to a low speed setting. Adjust to a higher speed setting.
WEAK OR
Airflow is blocked. Remove obstruction.
SLOW
Adjust direction of airflow towards the user.
GFCI HAS
Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip when the user is changing speeds on a
TRIPPED
Vornado circulator. In this event, change to an outlet that is not connected to a GFCI device. It could also indicate a weak or defective GFCI outlet.
Contact a qualified electrician to check the GFCI outlet.
English 13