Storage; Troubleshooting - Vornado PIVOT-EU Guide De L'utilisateur

STORAGE

During the off-season or after extended periods of non-use, you may choose to store
your circulator. To ensure long life of the product, it is recommended to store your
circulator by following these instructions:
Cleaning is recommended before storage.
1. Unplug power cord and bundle loosely.
2. Cover, or place back in retail carton if available.
This prevents circulator from accumulating dust
over time.
3. Store circulator in cool and dry location.
16 English

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
The unit fails to
Unit is not plugged in. Plug Power Cord into electrical outlet.
power on.
Ensure unit fan speed setting is selected.
Unit is damaged or in need of repair. Cease usage and unplug.
Contact Consumer Service for assistance.
The outlet is worn or damaged. Try another outlet or contact a
qualified electrician.
Airflow is weak
Unit set to a low speed setting. Adjust to a higher speed setting.
or slow.
Airflow is blocked. Remove obstruction.
Adjust direction of airflow towards the user.
GFCI has tripped.
Under certain conditions, it is possible for a reset GFCI (Ground
Fault Circuit Interrupter) outlet to trip when the user is changing
speeds on a Vornado circulator. In this event, change to an outlet
that is not connected to a GFCI device. It could also indicate a
weak or defective GFCI outlet. Contact a qualified electrician to
check the GFCI outlet.
17
English