Product Parts - Peg-Perego Si Notice D'emploi

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: Keep these instructions for future
reference. Read and keep them for safety use.
The child's safety could be at risk if these
instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This product is approved for children from birth up to
a weight of 15 kg in the seat.
_ For new born babies is recommended to use the
backrest in the most reclined position.
_ WARNING Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use.
_ WARNING The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system. Always
use the five point harness. Always use the harness
crotch strap in combination with the waist strap.
_ WARNING Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_ WARNING To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING This product is not a toy. Do not let your
child play with this product
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support
the child's weight. It is not designed to keep the child
in the seat and does not substitute for the waist belt.
_ Do not load the baskets over 5Kg. Do not put weight
in the cup holder (if present) in excess of those
indicated on the cup holders themselves and never
hot drinks. Do not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
_ WARNING This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING Do not add any mattress.
_ WARNING The front bar must always be in position
1 (raised) when the stroller is open and during use.
It should only be in position 2 (lowered) when the
stroller is folded up.

PRODUCT PARTS

Check the package contents and contact our Customer
Service for any claim.
_ Stroller Sì COMPLETO version is made up of the following
parts: 2 swivel/lockable front wheels, 2 rear wheels,
basket, hood, cover, rain canopy, 2 shoulder straps and 1
leg divider, 2 car seat strap adaptors.
_ The Sì CLASSICO stroller comprises: 2 swivel or
locking front wheels, 2 rear wheels, a basket, a hood,
2 shoulder padding sections for the harness and 1 leg
divider strap, 2 adaptor straps for attaching the Car
Seat.
INSTRUCTIONS
1• To open the chassis, pull the two levers on the
handlebars upwards (Fig.a); at the same time, lift the
chassis and it will open automatically (Fig.b). To make
sure that the stroller is correctly open, check the two
side hooks (Fig.c).
2• If the straps are not fasten correctly, press onto the
seat (fig_a) until it clicks into place.
Then push down into PUSH (fig. b) with your foot and
lift the front bar by one position (section 5b).
3• BASKET: To fit the basket, pull the loops over rear
hooks A and B and front hook C.
4• HANDLE ADJUSTMENT: The handles can be set at
3 different heights. To move them into the required
position, press the button and simultaneously pull the
handle upwards. To lower them, press the button and
push the handle down (fig_a).
BRAKE: To set the brake on the stroller, lower the lever
on the rear wheel unit with your foot. To release the
brake, lift the lever (fig_b). When stationary, always
apply the brake.
5• SWIVEL WHEELS: the wheels are already fixed into the
stroller.
In order to make the wheels swivel, the lever (arrow 1)
must be lowered. To secure the wheels, move the lever
to the opposite direction (arrow 2). The rear wheels
are fixed.
WARNING: Always keep the front bar fitted to the
stroller.
FRONT BAR: It is already attached to the stroller.
It can be put in 2 positions:
POSITION 1: Use.
POSITION 2: Folding.
To adjust it, press the two side buttons at the same
time (fig_b).
6• HOOD: To fit the hood, click the fasteners onto the
appropriate points and button down the hood on the
- 13 -