Connecting The Speaker Output Terminals - Pioneer GM-D8604 Mode D'emploi

Section
03 Connecting the units
2 Use wire cutters or a utility knife to
strip the end of the battery wire, ground
wire and system remote control wire to ex-
pose about 10 mm (3/8 in.) of the end of
each of the wires, and then twist the ex-
posed ends of the wires.
3 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
6
4
1 Battery wire
2 Power terminal
3 Ground wire
4 GND terminal
5 System remote control wire
6 System remote control terminal
7 Terminal screws
12
En
Twist
10 mm (3/8 in.)
7
2
1
3
5
Connecting the speaker output
terminals
1 Use wire cutters or a utility knife to
strip the end of the speaker wires to ex-
pose about 10 mm (3/8 in.) of wire and
then twist the wire.
2 Connect the speaker wires to the
speaker output terminals.
Fix the wires securely with the terminal
screws.
1
1 Terminal screws
2 Speaker wires
3 Speaker output terminals
Twist
10 mm (3/8 in.)
3
2