Connecting The Speaker Output Terminals - Pioneer GM-6500F Mode D'emploi

Section
03 Connecting the units
WARNING
If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating, malfunction and injury, including
minor burns.
1 Route battery wire from engine com-
partment to the vehicle interior.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive (+) battery
terminal.
1 Positive (+) terminal
2 Engine compartment
3 Vehicle interior
4 Fuse (30 A) × 2
5 Insert the O-ring rubber grommet into the
vehicle body.
6 Drill a 14 mm hole into the vehicle body.
2 Twist the battery wire, ground wire
and system remote control wire.
3 Attach lugs to wire ends.
Use pliers, etc., to crimp lugs to wires.
10
En
1 Lug (sold separately)
2 Battery wire
3 Ground wire
4
Fix the wires securely with the terminal
screws.
1 System remote control terminal
2 Ground terminal
3 Power terminal
4 Terminal screws
5 Battery wire
6 Ground wire
7 System remote control wire
Connecting the speaker
Twist
output terminals
1
strip the end of the speaker wires to ex-
pose about 10 mm of wire and then twist
the wire.
Connect the wires to the terminal.
Use wire cutters or a utility knife to
Twist