Connecting The Speaker Output Terminals; Using The Speaker Input - Pioneer PRS-D420 Mode D'emploi

Connecting the Unit
Connecting the Speaker Output
Terminals
• Use a 10 AWG to 16 AWG wire for the speaker
wire.
1. Expose the end of the speaker wires
using nippers or a cutter by about
10 mm to 12 mm.
2. Connect the speaker wires to the
speaker output terminals.
• Fix the speaker wires securely with the termi-
nal screws.
Terminal screws
Speaker output
terminal

Using the Speaker Input

Connect the car stereo speaker output
wires to the amplifier using the supplied
speaker input wire with RCA pin cord.
• Slide the input switch to the right (SP).
9
10 mm to 12 mm
Speaker wire
7 Connections when using the speaker
input
Car Stereo
White: Black:
Left + Left ≠
To RCA input
jack of this unit.
• As a result of connecting the car stereo speaker
output wire to the amplifier, the power of the
amplifier is turned on automatically when the car
stereo is turned on. It is not necessary to connect
the system remote control wire in this case.
• In the case the amplifier and head unit are con-
nected using a speaker input wire with RCA pin
cord, the amplifier power is only turned on when
one amplifier is being used. If two or more ampli-
fiers are synchronously connected in combina-
tion, connect the head unit and all of the ampli-
fiers with the system remote control wire.
Note:
• Connect the system remote control wire when the
power of the amplifier is not to be turned on
when the car stereo is turned on.
Speaker output
Black: Red:
Right ≠ Right +
Speaker input
wire with RCA
pin cord