Installation - Hoshizaki IM-240ANE Notice D'installation

ENGLISH

5. INSTALLATION

Incorrect installation can cause harm to people, animals or other items, for which the manufacturer cannot be held
responsible.
1) Lay the storage bin on its rear side carefully to prevent damage. Secure the four adjustable legs (bin accessory) into the four
tapped holes on the underside of the bin.
2) Position the storage bin in the selected permanent position, and level it in both the left-to-right and front-to-rear directions.
Adjustable Leg
3) Remove the icemaker panels. The rear panel is not required to be removed for installation. See "3. UNPACKING".
4) Place the icemaker on the top of the storage bin by holding the bottom.
5) Secure the icemaker to the storage bin at the rear, by using the mounting brackets and bolts provided.
6) Seal the seam between the icemaker and the storage bin with food grade sealant.
7) Remove the drain pipe collar and drain pan. Secure the bin control switch to the mounting frame using the two bolts provided.
Fix the bin control switch wiring with the two nylon ties. Place the ice chute on the unit frame, and refit the drain pan in its
correct position.
8) Replace the icemaker panels in their correct position.
Mounting Bracket
Bolt
CAUTION
Bottom
Icemaker
Bin
Mounting Bracket
4
Drain Pipe
Collar
Packing
Drain Pan
Adjustable Leg
Ice Chute
Unit Frame
Bolt
Tie
Mounting Frame
Bin Control Switch