Overview Of The Components / Scope Of Delivery; Notes For Use; Location; Connected Wattage - Proficook PC-EBG 1201 Mode D'emploi

Overview of the Components /
Scope of Delivery
1 Air inlet opening
2 Air outlet openings
3 Slot system
4 Control dial / START / STOP button (start / stop)
5 TEMP button (temperature)
6 TIME button (time)
7 Display
8 Air inlet openings
9 Housing
10 On / off switch ( / O)
11 Grill rack
12 Grease drip tray
13 Removal tool

Notes for Use

Location

• Set the appliance onto a non-slip, level, and heat-resist-
ant surface.
• Take care that the appliance and the mains cable never
are placed onto hot surfaces or near heat sources (e. g.
range, hob).

Connected Wattage

The total power consumption of this appliance can be up
to 1600 W. With this connected load a separate supply line
protected by a 16 A household circuit breaker is recom-
mended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.

Electric Connection

1. Before inserting the power plug into the outlet, check
that the mains voltage to be used matches that of the
appliance. You can find the required information on the
nameplate.
2. Connect the appliance to a properly installed earthed
socket.

Switching the Appliance On / Off

The on / off switch is located at the back of the appliance:
O = turned off
I = turned on
When turning on the appliance, a signal will sound and the
fan will turn on for about 3 seconds. The display will then
" next to the TEMP button and "
show "
the TIME button. In addition, all the indicator lights light up
briefly.
PC-EBG1201_IM

Standby (Standby Mode)

NOTE:
The appliance is in standby mode when the power plug
is plugged in, the switch is set to the position and the
display is not on.
• If no button is pressed for approx. 3 minutes, the appli-
ance will automatically switch into standby mode.
• You may exit standby mode by either pressing a button
or by using the control dial.

Buttons and Controls on the Control Panel

• The TEMP and TIME buttons on the appliance are touch
keys. Gently touch the buttons with a finger to execute
the function. Whenever a button is pressed, it will be
confirmed by a beep sound.
• The control dial has two different functions:
Turning:
- Selection of the automatic programs
- Change of temperature or time
Pressing:
- Starting and stopping the programs

Auto Functions

Use the control dial to select an automatic program. The
corresponding indicator light indicates the selected program.
Mode
(Entrecôte)
(Roast beef)
(T-Bone)
(Fillet)
(Chicken)
REST (Simmering)
NOTE:
• These shall be considered as guide values. Depending
on the size and weight, the time and temperature may
be longer and higher or shorter and lower.
• You may change the pre-set temperature and time of
the automatic programs as desired. However, this is
not possible with the " REST " program.
• Turn the meat over halfway through the cooking time.

Changing the Temperature

Press the TEMP button. The temperature display will start
flashing for about 3 seconds. During this time, use the
control dial to set the temperature.
" next to
Pre-set Pre-set time
temperature in °C in min.
850 3
850 5
850 7
800 4
850 4
300 5
05.09.19
43