Troubleshooting; Cleaning The Gas Barbecue; Exterior Surfaces; Interior Surfaces - Proficook PC-GG 1129 Mode D'emploi

Malfunctions are often just caused due to minor problems. Before contacting our customer service, please check the table below:
Problem
The burner cannot be lit with the ignition
system.
No yellow flame or back coupling (fire in the
burner line – hissing or bubbling noise)
WARNING: HOT SURFACES
Before cleaning, wait until the gas barbecue has cooled down sufficiently.
WARNING: RISK OF FIRE AND EXPLOSION
• Before cleaning the gas barbecue, remove the gas cylinder.
• Do not use any flammable detergents.
CAUTION:
• Do not use a wire brush or other abrasive utensils for cleaning.
• Do not use any oven cleaners. Oven cleaner attacks painted surfaces.
• The individual parts are not dishwasher-safe.
• Clean the barbecue after each use!
NOTE:
The deposits will be burned off nearly completely by operating the burner after each operation for ca. 15 minutes at maximum heat without any food.
Exterior Surfaces
• Use mild detergents, caustic soda and hot water.
• Mild abrasive agents can be used for stubborn stains.
• Following this, rinse thoroughly with water.

Interior Surfaces

Does the inner surface of the grill lid look as if paint may flake off? There is burnt-on grease which is flaking.
1. Clean the surface thoroughly with highly concentrated, hot soap suds.
2. Rinse thoroughly with water and allow the lid to dry.

Interior Surface of the Barbecue Tray

1. Remove residue with a brush or a scraper.
2. Using soap suds and a sponge, finish by washing the surface.
3. Rinse thoroughly with water and allow the surface to dry.

Barbecue Grille

• Remove residue with a brush or a scraper.
CAUTION:
If you want to use water, dry the barbecue grilles thoroughly afterwards to prevent rusting!
42
PC-GG1129_IM

Troubleshooting

Possible cause
Gas cylinder is empty
The regulator is damaged
The burner is blocked
The gas jets or hose is blocked
The electrode wiring is loose or separated from
the electrode or ignition
The electrode or cable is damaged,
faulty switch ignition
Gas cylinder is too small
Burner blocked (insect nest?)
The gas jets or hose is blocked
Draft

Cleaning the Gas Barbecue

Notes / Solution
Replace the gas cylinder
Check or replace the regulator
Clean the burner
Clean the jets and the hose
Reconnect the cable
Replace the electrode and the cable,
replace the ignition device
Use a larger cylinder
Clean the burner
Clean the jets and the hose
Set the barbecue up in a protected location
18.01.17