End Of Operation; Cleaning; Housing; Inner Surfaces And Slot System - Proficook PC-EBG 1201 Mode D'emploi

6. Pay attention to the markings on the grill grate. Place the
food in the centre of the marked area of the grill grate.
NOTE:
When the food is not placed in the marked area, it is
not optimally located beneath the heating element.
Thus, no perfect result can be achieved.
7. Insert the grill grate into a slot using the removal tool.
8. Observe the grilling process and, if necessary, turn the
food around.

End of Operation

There are two options to stop the operation:
• The appliance will turn off automatically after the set time
has elapsed.
• You press the control dial to end the program.
A signal will sound to confirm the end of the program.
CAUTION:
After the end of operation, the fans keep running to cool
down the appliance. Do not disconnect the appliance from
the mains during this period!
WARNING:
• Always turn the appliance off before cleaning it and remove the
mains plug. Wait until the appliance has cooled down.
• Do not immerse the appliance in water! Doing so may result in
an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Clean the barbecue after each use!
NOTE:
If the grill is left to burn on maximum heat for around
15 minutes without food to be grilled after operation, any
accumulations / deposits of grease will be almost com-
pletely burned away.

Housing

Clean the housing only with a damp cloth and a squirt of
detergent.
PC-EBG1201_IM
WARNING: Danger of Burns!
• Be careful when removing the grill grate!
• Allow the appliance to cool down before removing the
grease drip tray.
1. Remove the grill grate by using the removal tool. Put the
grill grate only on a heat-resistant surface!
2. Remove the grease drip tray.
3. Set the on / off switch, located at the back of the appli-
ance, into position O.
NOTE:
• The stainless steel surface of the front of the appliance
can become discoloured due to the high temperatures.
In addition, splashes of fat may accumulate.
• Promptly clean the appliance after it has cooled down.
This way you avoid "burning" in of this grease residue.

Cleaning

Inner Surfaces and Slot System

1. Remove the slot system.
2. Clean the surface thoroughly with highly concentrated,
hot soap suds.
3. Wipe off with water and leave the surface to dry.
4. Clean the slot system in a hot rinsing bath using a mild
soapsuds. For stubborn stains, you can also use a nylon
brush.
5. Once the slot system is dry insert it back into the appli-
ance.

Grill Rack and Grease Drip Tray

• Clean these parts in hot water by adding some wash-
ing-up detergent. For stubborn stains, you can also use
a nylon brush.
• Then dry the parts well.
45
05.09.19