en-us
,
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS!
Scope of Delivery
After unpacking all parts, check for any damage in
transit.
If there is damage, do not plug in your appliance.
Please contact the dealer.
The following parts are included:
Free-standing appliance
■
Interior fittings (depending on model)
■
Bag containing installation materials
■
Operating instructions
■
Installation instructions
■
Registration card
■
Information on energy consumption and noises
■
Installing the appliance
Have a qualified technician install and connect the
appliance according to the enclosed Installation
Instructions.
WARNING
:
Do not install the appliance:
outdoors,
■
in an environment subject to drips of water,
■
in rooms with risk of freezing temperatures.
■
Transporting
The appliance is heavy and must be secured during
transport and installation.
The castors are provided for installation purposes only.
Do not use the castors for transporting the appliance.
WARNING
:
Risk of injury!
The appliance is very heavy. It can fall over and
cause serious injuries during transport and
installation. At least two people are required to
install the appliance safely. Keep the refrigerator
doors closed until the appliance is upright and level
at the installation location.
Hidden surfaces may have sharp edges. During
transport, wear protective gloves. Use caution when
reaching behind or under appliance.
6
Installation location
WARNING
:
Risk of explosion!
Do not install the appliance near explosive or
flammable substances.
A dry, well-ventilated room is suitable as an installation
location. The installation location should not be
exposed to direct sunlight or placed near a heat
source, e.g. a cooker, radiator, etc. If installation next to
a heat source is unavoidable, use a suitable insulating
plate or observe the following minimum distances from
the heat source:
1
/
" (3 cm) to electric or gas stoves.
1
■
4
11
/
" (30 cm) to oil or solid fuel stoves.
13
■
16
To ensure that the Ice Maker functions correctly, the
appliance must be upright and level.
If installing the refrigerator next to another refrigerator/
freezer, there must be a minimum clearance of
1" (25 mm) between the appliances to prevent
condensation.
If a panel or cupboard is installed above the appliance,
ensure to leave a
/
" (10 mm) gap so that the
13
32
appliance can be pulled out of the recess if required.
The air heated at the back of the appliance must be
allowed to escape unhindered.
To ensure that the doors can open all the way, maintain
the lateral minimum clearances when installing the
appliance in a corner or recess (see section
"Installation dimensions").
If the depth of the adjacent kitchen equipment exceeds
29
/
" (75 cm), maintain the minimum lateral
1
8
clearances in order to utilize the full door opening angle
(see section "Door opening angle").