Scope Of Delivery; Installing The Appliance - Bosch B26FT Serie Mode D'emploi

en-us
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS!

Scope of Delivery

After unpacking all parts, check for any damage in
transit.
If there is damage, do not plug in your appliance.
Please contact the dealer.
The following parts are included:
Free-standing appliance
n
Interior fittings (depending on model)
n
n Bag containing installation materials
Operating instructions
n
n Installation instructions
n Registration card
n Information on energy consumption and noises

Installing the appliance

Have a qualified technician install and connect the
appliance according to the enclosed Installation
Instructions.
WARNING
Do not install the appliance:
outdoors,
n
n in an environment subject to drips of water,
in rooms with risk of freezing temperatures.
n
Transporting
The appliance is heavy and must be secured during
transport and installation.
The castors are provided for installation purposes
only.
Do not use the castors for transporting the appliance.
WARNING
Risk of injury!
The appliance is very heavy. It can fall over and
cause serious injuries during transport and
installation. At least two people are required to
install the appliance safely. Keep the refrigerator
doors closed until the appliance is upright and level
at the installation location.
Hidden surfaces may have sharp edges. During
transport, wear protective gloves. Use caution
when reaching behind or under appliance.
6
Installation location
WARNING
Risk of explosion!
Do not install the appliance near explosive or
flammable substances.
A dry, well-ventilated room is suitable as an installation
location. The installation location should not be
exposed to direct sunlight or placed near a heat
source, e.g. a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use a suitable
insulating plate or observe the following minimum
distances from the heat source:
1/4 I
1 (3 cm) to electric or gas stoves.
n
3/16 I
n 11 (30 cm) to oil or solid fuel stoves.
To ensure that the Ice Maker functions correctly, the
appliance must be upright and level.
If installing the refrigerator next to another
refrigerator/freezer, there must be a minimum
clearance of 1" (25 mm) between the appliances to
prevent condensation.
If a panel or cupboard is installed above the
appliance, ensure to leave a 13/32
that the appliance can be pulled out of the recess if
required.
The air heated at the back of the appliance must be
allowed to escape unhindered.
To ensure that the doors can open all the way,
maintain the lateral minimum clearances when
installing the appliance in a corner or recess (see
section on "Appliance and installation dimensions").
If the depth of the adjacent kitchen equipment
1/8 I
exceeds 29 (75 cm), maintain the minimum lateral
clearances in order to utilize the full door opening
angle (see section "Door opening angle").
Climatic classes
The climate class can be found on the rating plate.
The climate class indicates within which ambient
temperatures the appliance can be operated.
Climatic class
Permitted ambient temperature
SN 50 °F to 90 °F (+10 °C to 32 °C)
N 61 °F to 90 °F (+16 °C to 32 °C)
ST 61 °F to 100 °F (+16 °C to 38 °C)
T 61 °F to 110 °F (+16 °C to 43 °C)
I
(10 mm) gap so