Connecting Recording Components; Cd Recorder / Md Recorder / Tape Deck; Connecting An Antenna; Am/Fm - Denon RCD-M38 Manuel De L'utilisateur

Connecting recording components

CD recorder / MD recorder / tape deck

Audio cable (sold separately)
(White)
Stereo L
pin-plug cable
(Red)
R
CD recorder /
MD recorder /
Tape deck
L R L R
L R L R

Connecting an antenna

AM/FM

• Connect the FM antenna or AM loop antenna included with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
L
(vpage 14 "Tuning in Broadcast Stations"), use tape to fi x the
R
antenna in a position where noise is the lowest.
AM loop antenna
(Supplied)
White
q
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. Inquire at the retail store where you
purchased the unit for details.

Using the AM loop antenna

n To use suspended on
a wall
Suspend directly on the wall
without assembling.
FM indoor antenna
(Supplied)
Nail, tack, etc.
Black

Assembling the AM loop antenna

Put the stand section
1
through the bottom of
the loop antenna from the
rear and bend it forward.
Insert the projecting part
2
into the square hole in the
stand.
w e
ENGLISH
n To use standing alone
Use the procedure below to
assemble.
Stand
Square
hole
Loop
Projecting
antenna
part
9