Other Functions; Turning The Clock Display On Or Off; Using The Aux Source; About Aux1 And Aux2 - Pioneer PREMIER SUPER TUNER III D+ DEH-P800PRS Mode D'emploi

Other Functions

Turning the clock display
on or off
You can turn the clock display on or off.
% Press CLOCK to turn the clock display
on or off.
Each press of CLOCK turns the clock display
on or off.
Note
Even when the sources are off, the clock display
appears on the display. Pressing CLOCK when
the sources and feature demo are off, turns the
clock display on or off.

Using the AUX source

Up to two auxiliary devices such as VCR or
portable devices (sold separately) can be con-
nected to this unit. When connected, auxiliary
devices are automatically read as AUX sources
and assigned to AUX1 or AUX2. The relation-
ship between AUX1 and AUX2 sources is ex-
plained below.

About AUX1 and AUX2

There are two methods to connect auxiliary de-
vices to this unit.
AUX1 source:
When connecting auxiliary equipment using a
2.5 mm stereo plug cable
1 Press and hold EJECT to open the front
panel.
AUX1 input jack appears.
2 Insert the 2.5 mm stereo plug into the
AUX1 input jack on this unit.
This auxiliary device is automatically set to
AUX1.
AUX2 source:
When connecting auxiliary equipment using an
IP-BUS-RCA Interconnector (sold separately)
% Use an IP-BUS-RCA Interconnector such
as the CD-RB20/CD-RB10 (sold separetely)
to connect this unit to auxiliary equipment
featuring RCA output.
For more details, refer to the IP-BUS-RCA Inter-
connector owner's manual.
This auxiliary device is automatically set to
AUX2.
# You can only make this type of connection if
the auxiliary device has RCA outputs.

Selecting AUX as the source

% Press SOURCE to select AUX as the
source.
Press SOURCE until AUX appears in the dis-
play.
# If the auxiliary setting is not turned on, AUX
cannot be selected. For more details, see Switch-
ing the auxiliary setting on page 71.

Setting the AUX title

The title displayed for the AUX1 or AUX2
source can be changed.
1 After you have selected AUX as the
source, use MULTI-CONTROL and select
FUNCTION to display TitleInput "A".
Section
15
75
En