Selecting A Channel In The Channel Category; Displaying The Radio Id; Channel Number Select Setting; Channel Category Select Setting - Pioneer PREMIER SUPER TUNER III D+ DEH-P800PRS Mode D'emploi

XM tuner
1 Use MULTI-CONTROL to select
FUNCTION.
Channel mode appears on the display.
2 Press MULTI-CONTROL to select the de-
sired channel select setting.
Press MULTI-CONTROL repeatedly to switch
between the following channel select settings:
Channel number (channel number select set-
ting)—Category (channel category select
setting)
# You can also select the XM channel select set-
ting by pressing and holding CLOCK.
Selecting a channel in the
channel category
1 Select the channel select settings to
Category.
Refer to Switching the XM channel select mode
on the previous page.
2 Push MULTI-CONTROL up or down to
select the desired channel category.
3 Push MULTI-CONTROL left or right to
select the desired channel in the selected
channel category.

Displaying the Radio ID

Channel number select setting

If you select CH 000, the ID code is displayed.
% Push MULTI-CONTROL left or right to
select CH 000.

Channel category select setting

RADIO ID is provided as a channel category
for displaying the ID code.
% Push MULTI-CONTROL up or down to
select RADIO ID from channel category.
# If you select another channel, display of the ID
code is canceled.
# Display of the ID code repeats displaying
RADIO ID and the ID code one after the other.
Selecting stations from the
preset channel list
The preset channel list lets you see the list of
preset stations and select one of them to re-
ceive.
1 Turn MULTI-CONTROL to switch to the
preset channel list mode.
# You can also perform this operation by press-
ing joystick on the remote control.
2 Use MULTI-CONTROL to select the de-
sired station.
Turn to change the station; press to select.
# You can also change the station by pushing
MULTI-CONTROL up or down.
# If you do not operate the list within about 30
seconds, the preset channel list mode is can-
celed automatically.
Notes
! You can also recall stations assigned to preset
tuning numbers by pushing MULTI-CONTROL
up or down during the channel display.
! You can also recall stations assigned to preset
tuning numbers by pressing one of the preset
tuning buttons 1 to 6 on the remote control.
Section
09
43
En