Safety; Important Safety Instructions - Bosch 300 Série Guide D'utilisation Et D'entretien

Safety

Important Safety Instructions

READ AND SAVE THESE INSTRUCTIONS
WARNING:
When properly used and cared for, your new
appliance has been designed to be safe and
reliable. Read all instructions carefully before
use. These precautions will reduce the risk of
burns, electric shock, fire and injury to
persons. When using kitchen appliances,
basic safety precautions must be followed,
including those in the following pages.
Proper Installation and Maintenance
Have the installer show you the location of the circuit
breaker or fuse. Mark it for easy reference.
This appliance must be properly installed and grounded by a
qualified technician. Connect only to a properly grounded
outlet. Refer to the Installation Instructions for details..
WARNING:
• All ranges can tip.
• Injury to persons could result.
• Install anti-tip device packed with range.
• See installation instructions.
This appliance is intended for normal household use only. It
is not approved for outdoor or other non-household uses
(including sea or air-going vessels). See the Statement of
Limited Warranty. If you have any questions, contact the
manufacturer.
Do not store or use corrosive chemicals, vapors, flammables
or nonfood products in or near this appliance. The use of
corrosive chemicals in heating or cleaning will damage the
appliance and could result in injury. This appliance is
English 2
intended only for heated food preparatoin and should not
be used for any other purposes.
Do not operate this appliance if it is not working properly, or
if it has been damaged. Contact an authorized servicer.
Do not obstruct oven vents.
Do not repair or replace any part of the appliance unless
specifically recommended in this manual. Refer all
servicing to a factory authorized service center.
In the event of an error, the display flashes and beeps
continuously. If this happens during self-clean, disconnect
appliance from the power supply and call a qualified
technician.
In the event of an error, the display flashes and beeps
continuously. Disconnect appliance from the power supply
and call a qualified technician.
Be sure your appliance is properly installed and grounded
by a qualified technician in accordance with the National
Fuel Gas Code ANSI Z223.- latest edition, or in Canada,
CAN/CGA B149.1, and CAN/CGA B149.2, and National
Electrical Code ANSI/NFPA No.70 - latest edition, or in
Canada CSA Standard C22.1, Canadian Electrical Code,
Part 1 and local code requirements.