Cleaning Agents; Catalytic Cooking Compartment Panels; Removing And Installing The Door Panels - Bosch HGL10E150 Notice D'utilisation

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, pay attention to the information in the
table. Do not use
sharp or abrasive cleaning agents,
■
cleaning agents with a high alcohol content,
■
hard scouring pads or cleaning sponges,
■
high-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Area Cleaning agents
Oven front Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
glass scrapers.
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues.
Special stainless steel cleaning prod-
ucts suitable for hot surfaces are availa-
ble from our after-sales service or from
specialist retailers. Apply a very thin layer
of the cleaning product with a soft cloth.
Aluminium Clean with a mild window cleaning agent.
Using a window cloth or a non-fluffing
microfibre cloth, wipe over the surfaces
lightly in a horizontal direction.
Enamel surfaces Apply commercially available washing-up
(smooth surfaces) liquid or a vinegar solution with a soft,
damp cloth or chamois; dry with a soft
cloth. Soak baked-on food residues with
a damp cloth and detergent. If the cook-
ing compartment is heavily soiled, use a
gel oven cleaner. This can be applied to
the affected area. Leave the cooking
compartment open after cleaning to
allow it to dry.
Self-cleaning sur- Note the instructions in the section:
faces (rough sur- Catalytic cooking compartment panel
faces)
Gas burner Never clean the gas burners in the cook-
ing compartment yourself.
Door panels Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Glass cover for the Hot soapy water:
oven light Clean with a dish cloth.
Seal Hot soapy water:
Do not remove. Clean with a dish cloth. Do not scour.
Rails Hot soapy water:
Soak and clean with a dish cloth or
brush.
Accessories Hot soapy water:
Soak and clean with a dish cloth or
brush.

Catalytic cooking compartment panels

The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
Self-cleaning surfaces
The side walls are covered with catalytic panelling. Never clean
these surfaces with oven cleaner. Slight discolouration of the
enamel does not affect automatic self-cleaning.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Removing the door panels
Open the oven door fully.
1.
Lock both hinges on the left and right using the locking pin.
2.
Note: The locking pins must be fully inserted into the holes in
the hinges.
Lift the bottom of the inner panel slightly until the fastening
3.
pins come out of the holder (1).
Carefully lift the top of the inner panel until the fastening pins
4.
come out of the holder (2).
Caution!
When lifting the inner panel, the middle panel may stick to the
inner panel. Make sure that the middle panel does not fall.
9