Technical Data - Grohe EUROSMART COSMOPOLITAN T 36 319 Instructions De Montage

GB
Application
Can be used in conjunction with:
• Pressurised storage heaters
• Thermally-controlled instantaneous heaters
• Hydraulically-controlled instantaneous heaters
Operation with unpressurised storage heaters is not possible.

Technical data

• Minimum flow pressure
• Operating pressure max.
• Recommended flow pressure
• Test pressure
If static pressures exceed 5 bar, a pressure-reducing valve
must be installed.
Avoid major pressure differences between hot and cold water
supply.
• Flow rate at 3 bar flow pressure
36 319:
36 320 (without downstream resistances):
• Temperature
Recommended (energy saving):
• Running time:
• Water connection
Installation
Flush piping system prior and after installation of fitting
thoroughly (Consider EN 806)!
Install S-unions and screw-mount the mixer, see fold-out
page II, Fig. [1].
Refer to the dimensional drawings on fold-out page I.
Install spout, see Fig. [2].
Swivel range can be adjusted by means of screws (A).
Open hot and cold water supply and check that
connections are watertight.
Operation
By pressing down the pushbutton cap, water flow is initiated
for the preset running time, see Fig. [3]. After expiry of the
preset time, the valve stops the flow of water automatically and
without kickback.
Setting temperature limiter
1. Loosen screw (B) (do not remove) and remove cap (C) with
temperature limiter and mixer spindle (G), see Fig. [4].
2. Loosen screw (D) and remove cap (C).
3. Remove feather key (E) from temperature limiter (F) and
reinsert in the desired position. The grooves in temperature
limiter (F) correspond to the temperatures that can be
selected, see Fig. [5].
Assemble in reverse order.
Screw (B) must engage in groove (G1) of mixer spindle (G),
see Fig. [6].
Setting the running time
1. Close water supply.
2. Unscrew cap (H) with cartridge, see Fig. [7].
3. Detach cylinder (I) from the cartridge.
4. The running time is changed by adding or removing insert
rings (J):
yellow + blue insert rings = ca. 7 s
yellow insert ring = ca. 15 s (factory setting)
no insert ring = ca. 30 s
5. Reattach cylinder (I) to the cartridge and refit the cartridge
with cap (H).
0.5 bar
10 bar
Maintenance
1 - 5 bar
16 bar
Shut off hot and cold water supply.
Inspect and clean all components and replace if necessary.
I. Remove and clean mousseur (13 960), see fold-out page I
Assemble in reverse order.
ca. 9 l/min
II. Cartridge, see fold-out page II, Fig. [7].
ca. 15 l/min
1. Unscrew cap (H) with cartridge.
max. 70 °C
2. Detach cylinder (I) from the cartridge and clean or replace.
60 °C
ca. 7 s/15 s/30 s
Assemble in reverse order.
cold - right
hot - left
III. Mixer spindle, see fold-out pages II, Figs. [4], [6] and [8].
1. Removal of cap (C) with temperature limiter and mixer
spindle is as described in section Setting temperature
limiter, see Fig. [4].
2. Remove screw (K) and remove temperature limiter (F), see
Fig. [8].
3. Replace mixer spindle (G).
Assemble in reverse order.
Screw (B) must engage in groove (G1) of mixer spindle (G),
see Fig. [6].
Replacement parts
see fold-out page I (* = special accessories)
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
2