Installation Instructions - BORETTI BKK-75 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation instructions

The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
Fitting - installing:
The piece of furniture or the support in which the hob is to be fitted, as well as the edges
of furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
• The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed with
plenty of space on either side. There may be a wall at the rear and tall units or a wall at one side.
On the other side, however, no unit or divider must stand higher than the hob.
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The cut out sizes are:
Worktop Cut-out (mm)
Width x Depth
750 x 490
• Materials which are often used to make worktops expand on contact with water. To protect
the cut out edge, apply a coat of varnish or special sealant. Particular care must be given to
applying the adhesive joint supplied with the hob to prevent any leakage into the supporting
furniture. This gasket guaranties a correct seal when used in conjunction with smooth work top
surfaces.
• Not to install the hob to the top of a not ventilated oven or a dishwasher.
• If a drawer is placed under the work, avoid to put into this drawer flammable objects (for
example: sprays) or not heat-resistant objects.
• The safety gap between the hob and the cooker hood placed above must respect the indications
of the hood manufacturer. In case of absence of instructions respect a distance minimum of
760 mm.
• The connection cord should be subjected, after building, with no mechanical constraint, such for
example of the fact of the drawer.
• The installation of the hob in nonstationary sites (for example: boat) should be undertaken by
specialists.
46
Glass size
Width
Depth
780
520
Thick
4

Publicité

Table des Matières
loading

Table des Matières