Dust Collection - Kreg Adaptive Cutting System Guide D'utilisation

Cord Manager
Installed on the infeed end of the guide
track, the cord manager prevents the power
cord and vacuum hose from catching on the
end of the track.
(1) Install the hex bolt, knob, and square nut
on the cord manager.
(2) Slide the assembly onto the infeed end of
the guide track, slipping the square nut
into the track T-slot.
(3) Tighten knob.
ATTENTION
The cord manager may have to be temporarily
removed when installing other accessories.

Dust Collection

(1) Align the large lug on dust bag with the
large slot on the dust port, push on the
dust bag and twist to lock. The 1.575"
[40mm] outside diameter, 1.378" [35mm]
inside diameter dust port also accepts a
vacuum hose.
(2) Rotate the port to orient the dust bag
or vacuum hose to the desired position.
(3) To empty, remove the dust bag and
unzip the end.
Adjust Tracking
(1) Loosen the tracking controllers.
(2) Place the saw on the guide track.
Tighten the tracking controllers to
eliminate play while allowing the saw to
slide on the guide track without binding.
SETUP
2
2
1
1
3
1
1
1
3
2
1