Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Bevel Overrides
Fitting two parts together when the edge
of one part is not square requires cutting a
slight compensating bevel on the second
part. When the needed bevel adjustment
falls below the 0° mark on the bevel scale,
use the -1° override. In similar fashion,
compensate for a miscut bevel on one part
of a miter joint by using the +47°override.
Both procedures are shown below.
-1° Override
(1) Loosen the bevel locks.
(2) Bevel saw to approximately 30º to access
the override locks
(3) Turn both -1° override locks to the
-1° position.
3
(4) Bevel saw down to -1º.
(5) Tighten the bevel locks.
To return to the 0-45° bevel range, loosen
the bevel locks, turn the -1° override locks to
the 0° position, tilt the saw down, and tighten
the bevel locks.
ATTENTION
Always return both override locks to the 0°
position after making your cut.
USING THE SAW
1
4
5
3
3
2
1
4
5
Publicité
Table des Matières
