Lubrication; Periodic Inspections - Kreg Adaptive Cutting System Guide D'utilisation

+47° override
(1) Loosen the bevel locks.
(2) Tilt the saw to 45°.
(3) Push down 47º override button.
(4) Tilt the saw to 47º.
(5) Tighten the bevel locks.
WARNING:
To reduce the risk of injury, disconnect the plug from the power source before performing any maintenance, adjustments, or when making repairs.
ATTENTION
To maintain product safety and reliability, and
to guarantee the use of genuine Kreg replacement parts, all repairs
and any maintenance or adjustment not covered in this manual
must be performed by Kreg Tool Company.
Cleaning
Blow dirt and dust out of all air vents,
air intakes, and blade housing with
compressed air at least once a week.
Never use solvents or other harsh
chemicals for cleaning the non-metallic
parts of the tool. Use a cloth dampened
only with water and mild soap. Never
let any liquid get inside the tool. Never
immerse any part of the tool in a liquid.

Lubrication

This tool comes lubricated for the life of
the unit from the factory. Under normal
operating conditions, no further
lubrication is necessary.
Motor Brushes
To prevent damage to the motor, this saw
features a brush system that automatically
stops the saw when the brushes wear out.
To have the brushes replaced, contact
Kreg Customer Service.
USING THE SAW
2
MAINTENANCE

Periodic inspections

Periodically inspect the operation of the plunge return. If the saw
returns slowly or if the blade fails to fully retract, the plunge return
assembly could be damaged. Do not attempt to repair.
Contact Kreg Customer Service for repairs.
Periodically inspect the operation of the anti-kickback control
during normal operation and check after every instance of
kickback. Inspect the anti-kickback components for visible damage.
Place the saw on the track with the anti-kickback control engaged
and pull back on the saw to verify that the saw does not move
backward. Do not attempt to repair the anti-kickback control.
Contact Kreg Customer Service for repairs.
Periodically inspect the operation of the riving knife.
The riving knife should move freely while plunging the saw.
Verify that the riving knife is centered within the width of the
blade teeth. Inspect the riving knife for bends, dents, or damage.
Do not attempt to repair or remove the riving knife.
Contact Kreg Customer Service for repairs.
Periodically inspect the power cord and plug for knicks, cuts,
or other damage. Do not attempt to repair the cord or plug.
Contact Kreg Customer Service for repairs.
Periodically inspect the operation of the switch and switch
interlock. Verify that both automatically return to the off position
when released. Do not use the saw if either the switch or switch
interlock is malfunctioning. Do not attempt to repair the switch or
switch interlock. Contact Kreg Customer Service for repairs.
1
3