Kreg Adaptive Cutting System Guide D'utilisation page 11

(5) Engage the anti-kickback control.
(6) Adjust the motor speed dial to maximum
speed (Setting 6).
(7) Connect the saw to power, press the
switch interlock button, and
(8) depress the switch.
ATTENTION
Both tracking controllers must engage the guide
track at the start of the cut. Stop the cut before the leading tracking
controller disengages from the guide track. A portion of the anti-chip strip
at both ends of the guide track remains untrimmed.
WARNING:
Always hold the saw with both hands when cutting.
Keep one hand on the switch handle and the other on the forward grip.
(9) Plunge the saw to the set depth and push
it along the guide track.
Trim the Splinter Guard
(1) With the saw on the track,
loosen the splinter guard screw and
lower the splinter guard until it contacts
the workpiece and secure splinter guard.
(2) Turn on the saw and plunge it
to cutting depth.
SETUP
6
1
5
9
7
8