Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Calibrate the bevel scale
WARNING:
Disconnect saw from power before making any adjustments.
ATTENTION
The saw blade is aligned perpendicular to the saw
base and the bevel indicator set at 0° at the factory. To ensure accurate
cuts, check the alignment and the position of the bevel indicator as
indicated below.
(1) Verify that the -1° bevel overrides are
in the 0° position. (See Bevel cuts in
the Using the saw section.)
(2) Adjust the cut-depth stop to full depth.
(3) Loosen the front and rear bevel locks.
(4) Remove splinter guard from blade
housing, then plunge the saw to full
depth and hold.
(5) Check the blade-to-base angle
with a square.
(6) Adjust the angle by turning the
set screws.
ATTENTION
Both set screws must be turned the same amount in
the same direction.
(7) Tighten the front and rear bevel locks.
(8) Set the bevel indicator to the zero mark
and reinstall the splinter guard.
Speed Control
(1) Turn the speed-control dial to adjust blade speed.
SAW MOTOR SPEEDS
Dial Setting Revolutions Per Minute (RPM)
1
2,000
2
2,200
3
3,000
4
3,900
5
5,000
6
5,500
MAX
6,000
SETUP
3
1
4
7
1
2
3
1
6
5
6
8
7
Publicité
Table des Matières
