Warnings; Arrangement For Installation; Instructions For Installation - Jacuzzi lodge MLS Manuel D'installation

Warnings

Make sure that all users know how to use the hot tub safely.
How frequently you should check water quality depends on
how frequently the hot tub is used.
Ensure that the chemicals used are suitable for use in hot
tubs; chemicals designed for swimming pools must not be
used as treatment of water in swimming pools and hot tubs
is very different.
CAUTION
Do not sit, walk or lie on the cover. Do not place objects
on it.
To prevent accidental falls into the hot tub, it is advisable
to install the key-locking system provided with the thermal
cover ( 4).
CAUTION
Read and follow all the instructions related to the use and
storage methods for chemical products, keeping strictly
to the manufacturers instructions on the packets.
Never clean the filter when the pump is running. Turn off the
main switch first.
Never start the pump and heater if the water level is not
above the highest whirlpool nozzles:
Always turn off the main switch when the hot tub is empty.
With the TEST button, periodically check the efficiency of the
circuit breaker installed up the line from the hot tub.
It is a good rule to empty the hot tub regularly (about every 4-8
weeks), in order to ensure a change of water and proceed with tub
cleaning.
If you are away for any length of time, it is advisable to empty the
hot tub, as long periods without carrying out water treatment can
damage the hot tub.
CAUTION
Before emptying, make sure that the chemical additive
values in the water are within the permitted limits.
If in doubt, contact the local authorities.
DO NOT EMPTY THE WATER INTO A SEPTIC TANK.
PLEASE READ THESE INSTRUCTIONS THOROUGH-
LY BEFORE INSTALLATION
CAUTION
The operations described in this manual must only be
performed by qualified specialist personnel.

Arrangement for installation

Refer to the pre-installation sheet provided with the product for the
arrangement of the plumbing and electrical connections and/or to
check their execution.
Check that the following have been provided:
- a system for filling the hot tub
- connections to the drain well
- installation of a water softener (upstream from the hot tub) if
the water is very hard
-connection of the electrical box installed on the spa-pak with
the electrical system of the building. The main disconnecting
switch is to be placed in a safe location that is accessible to users.
Also refer to the chapter on connections and electrical safety.
For outdoor installations, it is advisable to drain the ducts of
the electrical cables, to prevent possible water accumulation.
If the hot tub is installed indoors, remember that water
evaporation from the hot tub can cause very high levels of hu-
midity, especially if temperatures are very high, even if the ther-
mal cover is used. Natural or forced ventilation helps to maintain
personal comfort and reduce damage to the building.
Jacuzzi Europe shall not be held liable for any damage caused by
excessive humidity.
If installation is made indoors, it is advisable to provide a
drain system under the support area of the hot tub which is
connected to the main drain. Considering the large amount of
water in the hot tub, this precaution is advisable should there
be accidental water leakage.

Instructions for installation

The hot tub is carefully packed in wood crates that ensure pro-
tection during transport. Jacuzzi Europe S.p.A. shall not be
held liable for damage incurred during transport or interme-
diate storage. As soon as you receive the hot tub, it is therefore
important to check that the packaging is in perfect condition
and if not, immediately notify the forwarding agent.
( 1) Remove the hot tub from the packaging and from the
panels, if present ( 2-2a-2b).
Carefully inspect the hot tub before proceeding with instal-
lation, checking the correct position of the couplings, pipes and
clamps (check that they are not loose).
23