Britax B-Safe Instructions D'assemblage page 3

2 Connect the two L-shaped bars to complete the
support bar.
3 Insert the support bar into the Adapter Brackets until it
clicks into place.
4 Snap button position 1 is used for the Britax B-Safe 35
and B-Safe 35 Elite.
Snap button position 2 is used for older Britax B-Safe
car seats.
5 Place car seat on the car seat adapter brackets and
press down firmly until it clicks into place.
To remove car seat:
Follow the steps in your car seat' s instruction manual
to remove car seat from adapters.
To remove adapters:
6 Lift up on the release levers on each adapter and pull
upward to remove.
WARNING:
FOLLOW ALL THE INSTRUCTIONS AND WARNINGS IN
YOUR STROLLER'S INSTRUCTION MANUAL.
• Keep these instructions for future reference.
• Read these instructions carefully before use. Your
child' s safety may be affected if you don't follow these
instructions.
• NEVER leave child unattended.
• IMPORTANT! While the child is in the car seat, always
use the restraint system provided by the manufacturer.
• WARNING: Check that the car seat attachment devices
are correctly engaged before use.
• Accessories not approved by Baby Jogger® shall not be
used.
• Only use replacement parts supplied or recommended
by Baby Jogger®.
• Wipe clean using a damp cloth.
3