Beko CLEARPOINT HP100S040 Instructions De Montage Et De Service page 6

Content:
Introduction
These instructions for installation and operation will help
you to become more familiar with the CLEARPOINT
and enable you to utilize the device within the intended
scope of application. Furthermore, the instructions con-
tain important information for ensuring safe, correct and
economic operation.
The individual directions have to be followed precisely
as described in order to avoid hazards or damage. Ad-
ditionally, it will be necessary to observe the accident
prevention regulations valid in the operator's country and
at the place of installation together with the approved
rules of engineering practice concerning correct safety
and work procedures.
All persons carrying out the installation, commissio-ning,
maintenance or repair of the product on the operator's
premises must have read and understood these instruc-
tions for installation and operation. The instructions
should be permanently available at the place of instal-
lation.
6
english
I n t r o d u c t i o n . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
G u a r a n t e e . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S a f e t y r u l e s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Areas of application
Function ..........................................
Economic efficiency of filters
I n s t a l l a t i o n . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Filter element replacement
Technical data HP 100 .........................
Technical data HP 350 .........................
Technical data HP 500 .........................
Manufacturer's Declaration ...............
EC Declaration of Conformity .............
Guarantee
CLEARPOINT filters are built according to the state of
the art and the approved safety rules of engineering prac-
tice. However, the use of the product can endanger the
health & life of attending personnel or third parties and
can have a considerable negative effect on the product
itself or on other material assets if:
- the personnel is not properly trained,
- the product is used for purposes other than
the intended application,
- the device is not correctly serviced or main
tained.
This can render the guarantee invalid.
The devices are designed for gaseous neutral fluide of
group II, PED 97/23/EG which are free from any ag-
gressive substances, for pressure stages of max.100,
350 resp. 500 bar. Non-observance of this condition
excludes all liability claims.
In the interest of further development,
BEKO TECHNOLOGIES reserves the right to implement
changes at any time, while retaining the essential fea-
tures of the device, if such changes become necessary
to enhance the technical capacity of the device or for
reasons of safety or standard commercial practice.
CLEARPOINT HP 100 S040-M020, HP 350 S030-M015, HP 500 S030-S050
6
6
7
..................... 7
8
.......... 8
8
............ 9
18
20
22
24
30