Maintenance - Elinchrom ELB 1200 Manuel D'utilisation

User Manual
ERROR NUMBER
-1
-2
-3
-4
-9
EN
-15
-18
-19
-24
-26
-28
-60
-62
-99
-101

MAINTENANCE

The head requires only very little maintenance. To ensure secure operation please check the
following points regularly before connecting the head to the power pack:
Ensure that the contacts of the flashhead connector are clean and undamaged.
The flash cable should not have any marks or cuts. Important!!
Ensure that the plug-in flash tube and the glass dome are correctly fitted.
CAUTION!
Under no circumstances open any part of the equipment. The ELB 1200 unit is not user
serviceable and contains high voltage. In the event of difficulties contact your Elinchrom Service
partner.
REGULAR CHECK
National safety regulations require frequent safety checks of the electrical equipment. The ELB
1200 unit should be checked once a year. This check not only guarantees safety; it also protects
the value of the unit.
SHIPPING
To achieve maximum protection of the unit when sending it in for service, the original packaging
should be kept.
SALES / SERVICE / RENTAL
For service and sales, please contact your local ELINCHROM Distributor. For contact and
support, please visit http://www.elinchrom.com/support.php
20
DESRIPTION
Capacitors over voltage
System overheat
Discharge circuit fault
Charge Timeout
No input voltage on SMPS !
Charge MOS thermistor open
Discharge MOS thermistor open
capacitor thermistor open
Capacitor voltage symmetry error
Booster voltage error
Tube hanged
System peripheral bus error
System memory error
Uncategorized error
low battery level
SOLUTION
Restart -> Service
Wait until cooling down
Restart -> Service
Restart -> Service
Restart -> Service
Restart -> Service
Restart -> Service
Restart -> Service
OFF 10 min. Restart ->
Service
Restart -> Service
Restart -> Service
Restart -> Service
Restart -> Service
Restart -> Service
Warning