Delay Setup - Elinchrom ELB 1200 Manuel D'utilisation

To set the delay step to x 1, x 10 or x 100 steps press the
The flash before ready feature gives you the choice between flashing the unit before full recycle
or to be able to flash only when the unit has fully recycled. You can also define recycling time
depending on the battery level left.
DISPLAY OPTION
Flash Recycling time
mode
Flash before
ready
Mode
Stay on default if you wish to do normal flash photography.
SEQUENCE SETUP
Use sequence mode to catch a moving sequence in a series of single frames with a number
of indexed flash units, for example, of a jumping person in up to 20 different images. The
following setup must be programmed in order to use the features.
Unit address : Every unit requires its own address; every time a trigger is released the
corresponding flash unit will respond. Up to 20 units can be addressed.
Total units : Indicates the total number of addressed flash units.
Sequence timeout : Time after which the sequence restarts back to first addressed unit.
The timeout can be programmed from 0.1s to 5s. This setting is the wait time after a sequence
is stopped, before it will restart from the beginning of the sequence.

DELAY SETUP

Set a delay for your ELB unit to flash with the set delay after triggering (e.g. second curtain).
The delay refers to the time (in ms) in which the unit should fire a flash after the camera
shutter has been opened. The delay time can be programmed from 1ms (0.001 s.) to 10000ms
(10 s.), enabling flash to be combined with ambient light sources.
SUB- OPTION SUB-OPTION
Eco / default
/ fast
Normal /
Sequence
/ Delayed /
Strobo
Sequence Unit address
Sequence Total units
Sequence Sequence timeout
Delayed Delay
Strobo Hz
Strobo Duration
User Manual
button
SETTINGS
Yes/no
Yes/no
1 - 20
1 to 20
0.1''-5.0''
Steps: x1,
x10, x100
1 - 20
0.5 – 5.0 s
DEFAULT
SETTING
EN
Default
Normal
1
1
2.0''
100 ms
1
2.0 s
15