Maintenance, Care And Storage; Care And Maintenance; Replacing The Spike Drum; Ordering Replacement Parts - EINHELL NVK 1401 Mode D'emploi

Anleitung NVK 1401 SPK1
GB
Important!
The cutting unit rotates for a few seconds after the
motor is switched off.
Never attempt to manually stop the spike drum. In
the event that the spike drum strikes an object,
immediately switch off the scarifier and wait for the
roller to come to a complete stop. Then inspect the
condition of the spike drum. If the spike drum is
damaged, it must be replaced (see 10.).
Lay the power cable on the ground in front of the
outlet in a looped arrangement.
Scarify away from the outlet or cable and ensure that
the power cable always trails in the scarified grass
which will prevent the scarifier from traveling directly
over the cable.

9. Maintenance, care and storage

Maintenance and cleaning work on the scarifier as
well as removal of the safety devices may only be
performed when the motor is switched off and the
power cable has been pulled.
Worn out or damaged spike drums should only be
replaced by an authorized professional (see address
on warranty certificate).
Do not clean the scarifier with running water,
particularly with high-pressure water.
Ensure that all mounting components (i.e. bolts, nuts
etc.) are always tightened so that the scarifier can be
safely operated at all times.
Store your scarifier in a dry room. In order to ensure
that you enjoy your scarifier for many years to come,
all screwed parts, as well as the wheels and axles,
should be cleaned and lubricated.
Keeping your scarifier in good condition not only
ensures a long lifespan and
high-performance, but also enables the machine to
thoroughly scarify your lawn with minimal effort. For
best results, clean the scarifier with a brush or rag.
Do not use any solvents to remove dirt.
At the end of the season, perform a general
inspection of the scarifier and remove any residues
which may have accumulated.
At the start of each season, ensure that you check
the condition of the scarifier.
If repairs are necessary, please contact one of our
customer service centers (see address on warranty
22
20.09.2006 15:10 Uhr Seite 22
certificate).
The push bar has a "P" and an "A" position (Fig. 17)
in order to save space during storage.
When the bar is moved to the "P" position, the
scarifier takes up less space and can be pushed into
a corner (Fig. 18).
In the "A" position, the scarifier can be folded up and
hung on the supplied wall holder as shown in Fig.
19.

10. Replacing the spike drum

For safety reasons, we recommend having the spike
drum replaced by an authorized professional (see
address on warranty certificate).
Important!
Wear work gloves!
Only replace the unit with a genuine Einhell spike
drum , as this will ensure top performance and safety
under all conditions.

11. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

12. Technical data

Voltage:
Power consumption:
Working width:
Number of blades
Scarifying depth:
L sound pressure level:
pA
L sound power level:
WA
Vibration on the shaft a
230 V ~ 50 Hz
1400 W
33 cm
20 pieces
- 3 / 3 / 7 / 9 mm
78 dB(A)
99 dB(A)
3.9 m/s 2
hv