Table des Matières
Publicité
Anleitung HS 550 SPK 1
27.10.2005
GB
The twin-bladed cutters rotate in opposite direc-
tions, thus enabling cutting in both directions (see
Figure 6).
It is recommended to tie a guide line of string or
the like along the hedge so that you cut the hedge
to a level height. Cut off all branches which protru
de beyond the guide line (see Figure 7).
Cut the sides of the hedge with curve-shaped
movements from the bottom up (see Figure 8).
8. Maintenance, care and storage
Before you clean the machine or put it away,
switch off and pull out the power plug.
The cutters should be cleaned and lubricated at
regular intervals in order to ensure best perfor
mance at all times. Remove deposits with a brush
and apply a thin film of oil (see Figure 9).
Please use biologically degradable oils.
Clean the plastic body with a mild household clea-
ning agent and a damp cloth. Do not use aggres-
sive agents or solvents.
Prevent water getting inside the device at all cost.
9. Troubleshooting
The machine does not work: Check that the power
cable is connected properly and check the mains
fuses. If the machine will not work in spite of the
voltage supply being OK, please send it to the
specified after-sales service address.
10. Waste disposal
Important!
The hedge trimmer and its accessories are made of
various types of material, such as metal and plastic.
Defective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
14
15:58 Uhr
Seite 14
Publicité
Table des Matières
