Makita UB001C Manuel D'instruction page 9

You can use the machine in the Boost mode. In the
Boost mode, the air volume becomes larger than in the
normal mode. To use the machine in the Boost mode,
pull the switch trigger until the switch trigger stops in the
halfway position, and then pull the switch trigger fully.
► 1. Switch trigger
NOTE: Depending on the usage conditions, use of
the Boost mode is restricted to protect the machine.
If the main power lamp of the machine blinks in green
when you pull the switch trigger fully or while you
are using the machine in the Boost mode, the Boost
mode is not available.
NOTE: The Boost mode is not available by turning
the control lever.
Cruise control function
The cruise control function allows the operator to main-
tain a constant speed without pulling the trigger. To
increase the speed, turn the control lever forward. To
decrease the speed, turn the control lever backward.
► 1. Control lever
1
1
9 ENGLISH
Accidental re-start preventive
function
Even if you connect the portable power pack to the
machine while pulling the switch trigger, the machine
does not start. To start the machine, first release the
switch trigger and return the control lever fully, and then
pull the switch trigger.
OPERATION
Connecting the portable power pack
CAUTION:
When you use the machine in com-
bination of the backpack-type power supply such
as portable power pack, use the hanging band
included in the machine package or the hanging
band recommended by Makita.
If you put on the shoulder harness not recommended
by Makita and the shoulder harness of the back-
pack-type power supply at the same time, removing
the machine or backpack-type power supply is dif-
ficult in case of an emergency, and it may cause an
accident or injury. For the recommended hanging
band, ask Makita Authorized Service Centers.
CAUTION:
Before operation, make sure that
the buckles on the waist belt is locked and the
machine is securely attached to the hook of the
hanging band.
CAUTION:
To prevent unintentional start up,
make sure that the machine and portable power
pack are turned off before starting this procedure.
CAUTION:
Before performing this procedure,
finish the adjustments for the waist belt and
shoulder harness. Refer to the instruction manual of
the portable power pack for details.
NOTE: Before performing this procedure, install the
battery cartridge(s) to the portable power pack. Refer
to the instruction manual of the portable power pack
for details.
1.
Pull out the cord from either left or right side of the battery.
When pulling out the cord, be sure to set the cord in the
holders as shown in the figure.
► 1. Cord 2. Holder
1
2