Smartline
6.1 Replacing the outlet filter
• Unscrew and remove the screw cap (1) at the back end of
the probe.
• Unscrew the knurled nut (4).
• Remove the filter element (3) and seals (2).
• If necessary, clean the inside of the heating tube by blow-
ing it out or using a cleaning wand.
• Replace the seals (2) before installing the new filter ele-
ment (seals are included with the filter element).
• Assemble in the reverse order.
• Then screw in the screw cap (1) with the new filter ele-
ment.
1
1 Screw cap
3 Filter element
7 Service and Repair
Please refer to the original operator's manual on the included
CD or online at www.buehler-technologies.com for a detailed
description of the unit including information on
troubleshooting and repair.
BX464002 ◦ 08/2020
2
3
2
2 Seal
4 Knurled nut
4
Bühler Technologies GmbH
11