LGB 22355 Instructions De Service page 8

Multi-Train System
This model has a direct decoder
interface. It can be equipped with
an LGB Multi-Train System Deco-
der (55020). The Decoder Interfa-
ce Cable (55026) is not required.
We strongly recommend decoder
installation by an LGB service
station. For more information,
contact your authorized LGB
retailer or an LGB service station
(see Authorized Service).
Hint: If this model is equipped
with a decoder, the digital/analog
DIP switches on the loco circuit
board will be set to OFF. The DIP
switches should remain in this
setting, even if the model is used
on an analog layout.
CAUTION! If this model is equip-
ped with a Multi-Train System
decoder, it must not be operated
with catenary power. Operate
decoder-equipped
track power only.
Lighting
This model has automatic direc-
tional lanterns: one white lantern
on the front and a red taillight on
the rear. If you run the streetcar
with an attached car, you can
switch off the taillight (see Opera-
ting Modes).
This model has "flat" multi-purpo-
se sockets,
covers, on the front and rear of
the streetcar (Fig. 6). These
sockets can be used to provide
track power to cars with lighting or
sound electronics.
To remove the cover of the
socket, pull it straight out. If the
cover is tight, gently use a small
straight screwdriver to pry it out.
(Do not pull out the rectangular
outer housing.)
Power Supply
Attention! For safety and reliabi-
lity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies with an output of at
least 1 amp. For more informati-
on on LGB power supplies for
indoor, outdoor and multi-train
operation, see the LGB catalog.
8
locos with
with removable
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Servi-
ce).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Replacing the light bulbs
Front/rear lantern: Remove the
ring around the lantern lens.
Carefully pry the lens away from
the lantern. Using tweezers,
remove and replace the bulb.
Reassemble.
Interior lights: Remove the roof
(see Operating modes, Fig. 5).
Remove and replace the bulb.
Replacing the traction tire
- Use a small, straight-blade scr-
ewdriver to pry the old traction
tire out of the wheel groove.
- Use a small, straight-blade scr-
ewdriver to gently pry the new
traction tire into the wheel groo-
ve.
- Make sure that the traction tire is
seated properly in the wheel
groove.