Use - Maxx-world 42801A0 Mode D'emploi

Use

ATTENTION!
■ Risk of injury associated with sharp blades! Never hold the blade adapters by the
blades. Handle the blade adapters with care in order to prevent cut injuries.
■ Never place the blade adapter without the blending container in the motor unit.
■ Risk of damage due to insuffi cient cooling! Never place the motor unit on a soft
base. The vents on the side and bottom of the motor unit must not be covered.
■ Burn hazard! Never fi ll the blending container with boiling hot food or liquids! The
content must not be warmer than 50 °C.
■ Make sure that the maximum fi lling capacity (mark on the blending containers) is not
exceeded!
■ Always add a small amount of liquid to the blending container if you would like to
process frozen fruits or vegetables.
■ Before you use the device, make sure that all parts of the device are properly seated.
■ Do not leave the device unattended when in operation.
■ During operation, make sure the device has a stable position. Always fi rmly hold the
motor unit with one hand.
■ The device must not be transported when switched on.
■ Use the device continuously for no more than 1 minute without stopping to prevent it
from overheating. Then, let the device cool off for a short time before using it again.
■ Always let the blades come to a full stop prior to removing the blending container.
■ Be absolutely sure to store prepared meals in the fridge. Do not consume any spoiled
food and only use ingredients whose best before date has not expired yet.
■ The storage lid is not suitable for the transportation of liquids!
1. Place the motor unit on a dry, level and solid base. Press down the suction feet on
the base.
2. Choose one of the two blending containers and add the desired ingredients to the
blending container (do not exceed the mark in the blending container!).
The shaker lid, the to-go lid and the storage lid can be used on
both the small and large blending container.
Please note that only the to-go lid is suitable for the transpor-
tation of liquids. Each time before you use the device, make sure
that the gasket is properly inserted in the groove.
17 EN