Danger Of Electric Shock; Danger Of Fire - Maxx-world 42801A0 Mode D'emploi

EN

Danger of Electric Shock

■ Use and store the device only in closed rooms. Do not operate the device in rooms
with high humidity.
■ Never immerse the motor unit, mains cable or mains plug in water or other liquids and
ensure that they cannot fall into water or become wet.
■ Should the motor unit fall into water, switch off the power supply immediately. Do not
attempt to pull the device out of the water while it is still connected to the mains pow-
er! Have the device checked in a specialist workshop before using it again.
■ Never touch the device, mains cable or mains plug with wet hands when these com-
ponents are connected to the mains power.
■ Only connect the device to a properly installed plug socket. The plug socket must
also be readily accessible after connection so that the connection to the mains can
quickly be isolated. The mains voltage must match the technical data of the device.
Only use suitable extension cables whose technical data is the same as that of the
device.
■ The device must be switched off when inserting or removing the mains plug.
■ Remove the mains plug if a fault occurs during operation or before a thunderstorm.
■ Always pull the mains plug and never the cable.
■ Make sure that the mains cable is not squashed, bent or laid over sharp edges and
does not come into contact with hot surfaces.

Danger of Fire

■ Do not use the device in rooms containing easily ignitable substances or poisonous
and explosive fumes.
■ Do not operate the device on hot surfaces or close to a naked fl ame.
■ Do not cover the device during operation in order to prevent it from catching fi re. Do
not insert anything into the ventilation openings of the device and make sure that
these do not become clogged.
■ Do not place any highly fl ammable objects such as paper, cardboard or plastic in or
on the device.
Damage to Materials, Property and the Device
■ Always check the device for damage before putting it into operation. The device
should only be used when it is fully assembled, undamaged, and in working order!
■ Always place the device on a dry, level and solid base.
■ The device may not be used when it is empty. Do not allow the motor to run when the
device is empty.
■ Make sure that the maximum fi lling capacity (mark on the blending containers) is not
exceeded!
■ Use the device continuously for no more than 1 minute without stopping to prevent it
from overheating. Then, let the device cool off for a short time before using it again.
■ Do not transport the device during use.
■ Do not pull or carry the device by the mains cable.
■ Do not drop the device or subject it to heavy impacts.
14