Télécharger Imprimer la page

Startup Menu (Customizing) - LORCH BasicPlus Manuel D'utilisation

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 114

Startup menu (Customizing)

Code
Parameter
PPd
Analogue PushPull direc-
tion of rotation
GAF
Gas monitoring
Two different gas monitoring systems are available as an option.
Gas flow rate monitor:
The minimum gas flow rate can be set here. (0.0 = Gas flow rate
monitor deactivated)
Gas pressure monitor:
Here you can switch the gas pressure monitor on and off.
If the gas flow rate falls below the threshold or the minimum gas
flow rate, the welding machine goes into fault and displays the
corresponding error message.
IFn1)
Interface number
Stn1)
Status number
IFI1)
Interface mode ID
ndA1)
Node address
bdr1)
Baud rate
SAL1)
Station Alias
(not adjustable)
IPA1)
IP address (c00...c03)
Sub1)
Sub-net mask (c00...c03)
I6o1)
INT06 Option (c00...c11)
I2o1)
INT02 Option (c00...c02)
Tab. 3:
Parameter Machine Configuration
1)
Only available for welding machines in the automation field and connected Bus system or device interface.
02.20
Range
0
0...1
2.0
0.0...25 l/min
on
on...oFF
-
1...9
-
0...7
3
1...3
1
0...63
0
0...3
-
-
-
0.0.0.0...
255,255,255,255
-
-
on...oFF
-
on...oFF
1)
909.3049.9-03
8
Startup menu (Customizing)
The Startup menu contains additional functions, processes,
operating modes and special programmes.
As soon as the machine starts, you will be able
i i
to call up the machine service data using a
NFC-compatible mobile phone and send it by
entering an email address.
 Turn off the equipment using the main switch.
 Hold down the Menu button A2 and switch the device on
at the same time using the main switch.
or
 Press the Craterfill/Menu/Exit buttons A2 and the Weld
Method button A32 simultaneously for 3 seconds.
9 The NFC active LED lights up and nFc Act is shown on the
7-segment displays A4 and A12.
9 You can now hold a mobile phone against the NFC read
surface A43.
‰ This will display the machine service data on the phone.
 Press any key to jump directly to the Startup Menu.
Partial control panel brightness
 Use the rotary knob A41 to select the desired code br7,
brU or brP.
 Select the desired brightness with the control knob A44.
 Save the set value by pressing the Save button A14.
‰ The brightness of the following control panel areas can be
set.
Code
br7
Brightness of the 7-segment displays
brP
Process brightness, white LEDs
brU
Unit brightness, green LEDs
Tab. 4:
Partial control panel brightness
Control panel area
- 25 -

Publicité

loading