1
Control panel Basic Plus
A1
A40
A45
A37
A36
A35
A34
A33
A32
Fig. 1:
Control panel Basic Plus
A1
Crater filling LED
Lights up if the Crater filling function is selected
A2
Crate filling/Menu/Exit button
Crater filling = Press button briefly
Secondary parameters menu = Press the button for 2
sec.
Machine configuration menu = Press the button for 5
sec.
Exit = Menus are exited by pressing the button briefly.
A3
Admin LED
Lights up when a user with Administrator rights is
logged-in.
A4
7-segment display, left
Displays the selected material thickness, welding cur-
rent or wire feed speed.
If the menu is activated, the code of the parameter is
displayed.
A5
Reduce arc dynamics button
A6
Remote control LED
Lights up when a remote control is connected.
- 20 -
A6
A2
A3
A5
A7
A4
A8
A41
A31
A29
A27
A30
A28
909.3049.9-03
A9
A11
A13
A10
A12
A42
A44
A43
A7
Hold LED
Lights up at the end of a welding process. The most
recently used current strength and welding voltage
are displayed in the 7-segment display (A4 and A12).
A8
Menu LED
Lights up when the menu is activated.
A9
Arc dynamics display
Middle = 100%;
Grading towards minus = 70%, 40%, 10%
Grading towards plus = 130%, 160%, 190%
A10 Parameter value level display
Up arrow = The set value is higher than the standard
value.
Down arrow = The set value is lower than the standard
value.
A11 Increase arc dynamics button
A12 7-segment display, right
Displays the selected welding voltage, arc correction
or electrode material.
If the menu is activated, the value of the secondary
parameter is displayed.
Control panel Basic Plus
A14
A15
A16
A46
A19
A20
A21
A22
A23
A24
A26
02.20