Pentair TRITON NEO Manuel D'utilisation page 6

TROUBLESHOOTING
1. Short Cycle between backwashes.
A. Flow rate too high or filter too small: consult dealer for system sizing
recommendations.
B. Water is chemically out of balance: consult pool serviceman.
C. Excess dirt/dust in pool: vacuum pool directly to waste.
D. Body oil/lotion build-up in filter: consult dealer for chemical filter cleaners and
follow cleaner manufacturer's instructions.
TIME BETWEEN BACKWASHES WILL VARY WITH EACH INSTALLATION AND BETWEEN
DIFFERENT AREAS OF THE COUNTRY. ASK INSTALLER ABOUT NORMAL BACKWASH
INTERVAL IN YOUR AREA. THE FOLLOWING CAUSES AND REMEDIES ARE FOR CYCLE
TIMES SHORTER THAN NORMAL FOR YOUR AREA.
E. Filter inadequately backwashed:
See instructions page 5: "To clean (backwash) the filter..
F. Algae in pool: consult pool professional about proper chemical maintenance.
G. Residual chlorine level too low: consult pool professional about proper chemical
maintenance.
H. Inspect filter sand for solidification caused by dust, calcium, skin oils, of suntan
lotions.
2. Low Flow
A. Pipe blocked downstream from filter: remove obstruction.
B. Piping too small: use larger pipe (consult dealer for sizing).
C. Plugged pump; plugged hair and lint trap or skimmer basket. Clean thoroughly.
3. Pool Water Not Clear
A. Water is chemically out of balance: consult pool professional.
B. Filter is too small: consult dealer about equipment sizing.
C. Sand in pool means broken lateral. Drain both water and sand out of tank. Remove
valve and replace broken part. Reassemble filter.
WARRANTY
• The filters are resistant against swimming pool water treatment products. Maximum
working temperature is 50 degrees Celsius; maximum working pressure is 3.5 bar.
• Warranty period: 10 years on the shell, as from the production date.
6