Cooper Lighting Solutions Metalux CBRK CooperKit Instructions D'installation page 6

Installation Instructions – LED Retrofit Kit – CBRK CooperKit
Supply voltage connection :
11. Connect Supply voltage conductors and hide
connected wires behind LED Panel (B).
B
Figure 11.
Installation Closing Panel (D) :
Wavelinx: Before installing the closing panel connect
Wavelinx. See Wavelinx installation
instructions.
12. Install Closing Panel (D) in-between troffer and T-grid.
1
Figure 12.
13. Fixate panels and establish ground by turning each
fastener 90 degrees.
Figure 13.
6 COOPER LIGHTING SOLUTIONS
Supply
Voltage
2
D
1
90
O
IB519143EN Installation instructions
Remove LED protection :
14. Tear off LED protection.
Figure 14.
Installation Diffuser (E) :
15. Slide Diffuser (E) under the tabs on one side from
either Panel and press diffuser (E) over the tabs on
opposite panel. The installation is now complete.
E
Figure 15.
Connection 0-10V and STEP DIM
(Optional) :
16a. Optional: For connection CBRK 0-10V input, use
indicated connections on the driver.
CBRK 0-10V wiring diagram
0-10V
Figure 16a.
Class 1 Wiring
DIM+
}
or Class 2
DIM-
Circuit
0-10VDC