Cooper Lighting Solutions Metalux CBRK CooperKit Instructions D'installation page 4

Installation Instructions – LED Retrofit Kit – CBRK CooperKit
4. Disconnect existing fixture ballast from supply voltage.
Figure 4.
Figure 4a.
Notice
Make sure to remove packaging (except the LED protection*),
from CBRK components before installing.
Do not install with total power input greater than
power rating of original fixture.
When space in the troffer is limited, remove
original ballast.
* Remove LED protection just before installing the
Diffuser (E) (see step 14).
Installation of Side Panels (A) :
5. Install Side panels (A) in-between troffer and T-grid.
Figure 5.
4 COOPER LIGHTING SOLUTIONS
A
A
IB519143EN Installation instructions
6. Slide Side Panel (A) outwards as far as possible.
Figure 6.
Figure 6a.
Installation LED Panel (B) :
7. Install LED panel (B) in between troffer and T-grid,
making sure the tabs at each corner of the LED panel
slide into the respective slots on the side panel.
DO NOT
TOUCH LED
2
Figure 7.
B
1