Table des Matières
Publicité
1
A
B
AUDIO OUT
R
L
2
DC IN
8
OPR / CHG
12V
Connections
...
1
Connect the transmitter to the AV
unit.
A The cable can be connected directly to a stereo
mini jack or to a large stereo headphone jack if
the included plug adaptor is used.
a Portable CD player, headphone stereo, radio/
tape players, personal computer, etc.
OR
B Use the included mini jack/pin cord adaptor to
connect the transmitter to your equipment's
stereo pin terminals.
b Amplifier, TV set, video deck, cassette deck,
DVD player, personal computer, etc.
...
2
Connect the transmitter to a
household AC outlet using the
supplied AC power adaptor.
Disconnect the AC adaptor from the household AC
outlet if the unit is not going to be used for a long
time.
The unit is in the standby condition when the AC
adaptor is connected. The primary circuit is always
"live" as long as the AC adaptor is connected to an
electrical outlet.
Note
The OPR/CHG indicator lights in red when the
transmitter receives input. It does not light just by
connecting the transmitter to an AC power source.
Installation
This unit uses radio waves.
The waves can be transmitted to a range of up to
60 meters (200 ft.).
Note
Under optimum conditions, the headphones can pick up
clear signals from the transmitter to a maximum of
60 meters (200 ft.). Metal between the two units and
the presence of other radio waves can cause
interference to occur at a shorter distance. This
interference can be cleared by moving closer to the
transmitter, removing the obstructions, or changing the
transmission frequency (see page 14).
You may occasionally experience interference due to
dead spots in the area covered by the transmitter. This
phenomena occurs with any kind of radio signal and is
not a malfunction. Dead spots can be moved by moving
the transmitter and the headphones.
Publicité
Table des Matières
Dépannage
