Patio Heater Assembly - Hendi 272602 Mode D'emploi

PATIO HEATER ASSEMBLY

ASSEMBLY INSTRUCTIONS
Screwdriver / Adjustable Spanners / Wrenches
Leak Detection Solution one part detergent and three parts water
Assemble all nuts and bolts loosely at first. Tighten all connections
after completion of assembly. This eases your work and increase
the stability of your appliance.
Before assembly, make sure all protection packing material must
be moved.
Small deviations in equipment may occur. This is no lack of quality
but subject to improvements.
ASSEMBLY
SETP 1: Screw rear panel of housing to the base with 5pcs bolts
M5 x 10 and 5pcs washer. (Detail Abb. A)
SETP 2: Push the housing lid over rear panel of housing and place
onto rear panel of housing. Screw together the housing lid and
rear panel of housing with 5pcs bolts M5 x 10 and 5pcs
washers. (Detail Abb. B)
SETP 3: Fixing the post upwards onto the housing lid with 4pcs bolts
M5 x 10 and 4pcs washers, then put plastic cover through the
post. (Detail Abb. C)
SETP 4: Place the reflector to main burner using 3pcs wing nuts and
3pcs washers. (Detail Abb. D)
SETP 5: Tighten inner gas pipe to main burner (See Figure 1),
Then fix main burner to the post with 3 bolts M5 x 10 and 3pcs
washers. (Detail Abb. E)
SETP 6: Fix the door to housing. (See Figure 2 and Detail Abb. F)
SETP 7: Attach 3pcs stands to the base. (Detail Abb. G)
Use nails or rawlbolts which depending on the type of patio
floor to fix the base to the ground. (See Figure 3)
SETP 8: Collect the wheels parts together and fix the wheels to the
base. (See Figure 4)
Figure 3
Figure4
Detail A
Detail B
Detail C
Detail D
Detail E
Detail F
Detail G
8
15