Operating Instructions; Leak Testing - Hendi 272602 Mode D'emploi

OPERATING INSTRUCTIONS

LIGHTING
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM
MUST BE PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL KNOB
COUNTER-CLOCKWISE TO THE PILOT SETTING. PRESS KNOB IN AND HOLD FOR 1 MINUTE
BEFORE ATTEMPTING IGNITION.
Check all connections prior to each use.
Turn on main gas supply.
Depress control knob and turn knob counter-clockwise to PILOT position, hold in for 20 seconds.
While depressing, turn control knob counter-clockwise to engage striker. Striker should "Click-
Start" pilot flame. If pilot fails to ignite, repeat.
Once pilot has ignited, continue to depress the control knob for 30 seconds or until the pilot will
remain lit when the control knob is released. Turn knob counter-clockwise to the HIGH position
once the pilot will stay lit.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the
burner, turn the control knob to the pilot position. Then, turn the knob to the level of heat
desired.
RE-LIGHTING
Note: For your safety, Control Knob cannot be turned OFF without first depressing Control Knob in
PILOT position and then rotating it to OFF.
Turn Control Knob to OFF.
Wait at least 5 minutes, to let gas dissipate, before attempting to re-light pilot.
Repeat the "Lighting" steps.
TO EXTINGUISH
Hold knob depressed & turn the knob clockwise to 'OFF'
Close the valve of the gas cylinder or the regulator after use.
Allow this appliance to cool before moving.
Note: After use, some discoloration of the emitter screen is normal.

LEAK TESTING

NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
NEVER LEAK TEST WHILE SMOKING.
The gas connections on this appliance are leak tested at the
factory prior to shipment.
This appliance needs to be periodically checked for leaks and
an immediate check is required if the smell of gas is
detected.
Make a soap solution using 1 part of liquid dish-washing
soap to 3 parts water. The soap solution can be applied
with a soap bottle, brush, or rag to the leak tested points
shown in the figure above.
The valve of the gas cylinder should be in the OFF position
at this point of the leak test. Once the soapy solution is
applied to the gas connections, the valve of the gas
cylinder needs to be turned to the ON position.
Soap bubbles will begin to form in the soapy solution if a
leak is present.
In case of a leak, turn off the gas supply. Tighten any
leaking fittings, then turn the gas supply on and recheck.
Leak Test Point ① ② ③ ④
16