Patio Heater Assembly - Hendi 272404 Mode D'emploi

PATIO HEATER ASSEMBLY

ASSEMBLY INSTRUCTIONS
List of Required Tools: Philip Screwdriver
!
Leak Detection Solution one part detergent and three parts water
!
Assemble all nuts and bolts loosely at first. Tighten all connections after completion of assembly.
!
This eases your work and increase the stability of the appliance.
Before assembly, make sure all packing material and any transmit protection must be removed.
!
Small deviations in equipment may occur. This is no lack of quality but subject to improvements.
!
If any part is missing or damaged, do not attempt to assembly this product, Contact customer service for
!
replacement parts.
Assembly should be performed on a flat, level, non-abrasive surface.
!
ESTIMATED ASSEMBLY TIME: 45 minutes.
!
EN
STEP 1: Lie down tank housing assembly (K).
Open door and take out all parts.
STEP 3: Unscrews 2pcs Standard screws and washers (BB) from a Support Bar – Lower (F).
Insert Support Bar - Upper (E) to Support Bar - Lower (F) and fix by using 2pcs Standard screws and washers (BB).
Repeat this step to connect left 3sets support bars.
6
STEP 2: Keep tank housing in lie down position. Fix the
burner assembly (J) to tank housing by using 4pcs
Standard Screws and Washers (BB).